Section 176 (Emission Control System (2ZR-FE) (Service Information)): Canister: Installation: Installation

WARNING: This page is about a different car, the 2011 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CHARCOAL CANISTER ASSEMBLY
1. Install the 3 bolts and charcoal canister assembly.
  
  Fig 1: Remove/Install Charcoal Canister Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
2. Connect the charcoal canister filter sub-assembly and 2 clamps to the charcoal canister assembly.
  
  Fig 2: View Of Charcoal Canister Filter Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the purge line hose.
  
  Fig 3: Locating Purge Line Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the wire harness clamp.
5. Connect the vapor pressure sensor connector.
6. Connect the fuel tank vent hose to the charcoal canister.
  
  Fig 4: Locating Fuel Tank Vent Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002