Entry Lock And Unlock Switch: Installation: Installation

WARNING: This page is about a different car, the 2012 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY
1. Insert the front end of the front door outside handle assembly into the front door outside handle frame.
  
  Fig 1: Installing Front Door Outside Handle Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Insert the rear end of the front door outside handle assembly into the front door outside handle frame. Next, slide the front door outside handle assembly toward the front of the vehicle to install it.
3. Connect the connector.
  
  Fig 2: Locating Front Door Outside Handle Assembly Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR OUTSIDE HANDLE COVER . Refer to REASSEMBLY - Step 22
INSTALL FRONT DOOR SERVICE HOLE COVER . Refer to REASSEMBLY - Step 33
INSTALL FRONT DOOR TRIM BRACKET . Refer to REASSEMBLY - Step 34
INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY . Refer to REASSEMBLY - Step 40
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY . Refer to REASSEMBLY - Step 41
INSTALL FRONT ARMREST UPPER BASE PANEL (for Driver Side without Power Window) . Refer to REASSEMBLY - Step 46
INSTALL FRONT DOOR INSIDE HANDLE BEZEL . Refer to REASSEMBLY - Step 47