Park / Neutral Position Switch: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the park/neutral position switch to the manual valve shaft.
  
  Fig 1: Remove/Install Park/Neutral Position Switch Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Temporarily install the 2 bolts.
3. Install a new lock plate and tighten the nut.
  Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
  
  Fig 2: Remove/Install Lock Nut And Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Temporarily install the control shaft lever.
5. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
  
  Fig 3: Identifying Control Shaft Lever Angle
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the control shaft lever.
7. Align the groove with the neutral basic line.
  
  Fig 4: Aligning Groove With Neutral Basic Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Hold the switch in this position and tighten the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
9. Using a screwdriver, stake the nut with the lock plate.
  
  Fig 5: Remove/Install Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Install the control shaft lever with the washer and nut.
  
  Fig 6: Remove/Install Control Shaft Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
11. Connect the park/neutral position switch connector.
  
  Fig 7: Remove/Install Park/Neutral Position Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
1. Connect the transmission control cable to the bracket with a new clip.
  
  Fig 8: Locating Transmission Control Cable Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the transmission control cable assembly to the control shaft lever with the nut.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
INSTALL BATTERY CARRIER . Refer to INSTALLATION - Step 62
INSTALL BATTERY . Refer to INSTALLATION - Step 63
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL . Refer to INSTALLATION - Step 77
INSPECT SHIFT LEVER POSITION See step 1
ADJUST SHIFT LEVER POSITION See step 2
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY See step 1