DTC 01-DC: Transmission Error: Procedure

1. Check if the component shown by the sub-code is displayed in the check result of the other components.
   1. Check if DTC 01-DC is output for the other components.

      HINT: 

      If DTC 01-DC is output for any other components, check if the same physical address is displayed.

      Result

      Result	Proceed to
      DTC 01-DC is output and the same physical address is displayed	A
      DTC 01-DC is not output or the same physical address is not displayed	B

      HINT: 

      For the list of the components shown by sub-codes, refer to COMPONENT TABLE  in step 2.

B → See step   4 

A: Go to next step 

1. Enter diagnostic mode.
   Fig 1: Service Check Mode Flow Chart - Diagnostic Mode

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Press preset switch "2" to change the mode to "Detailed Information Mode".
3. Identify the component which has stored this code.
   COMPONENT TABLE
   
   

   Component	Physical Address
   Radio receiver assembly	190
   Multi-media interface ECU	388
   Satellite radio tuner	1F1

   HINT: 

   • The physical address "P440" shown in the above example indicates the stereo component amplifier.
   • For details of the DTC display, refer to DTC Check/Clear. Refer to DTC CHECK / CLEAR .

NEXT: Go to next step 

1. Select the component which has stored this code.
   COMPONENT TABLE
   
   

   Component	Proceed to
   Radio receiver assembly	Radio receiver communication error. Refer to Radio Receiver Communication Error
   Multi-media interface ECU	Multi-media interface ECU communication error. Refer to Multi-media Interface ECU Communication Error
   Satellite radio tuner	Satellite radio tuner communication error. Refer to Satellite Radio Tuner Communication Error

NEXT → END 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR .

   HINT: 

   If "01-DC" is output for only one component, this may not indicate a malfunction.

NEXT: Go to next step 

1. Recheck for DTCs and check if the same DTC is output again.

   OK

   No DTCs are output.

NG → See step   6 

OK → END 

1. Select the component which has stored this code.
   COMPONENT TABLE
   
   

   Component	Proceed to
   Radio receiver assembly	Radio receiver communication error. Refer to Radio Receiver Communication Error
   Multi-media interface ECU	Multi-media interface ECU communication error. Refer to Multi-media Interface ECU Communication Error
   Satellite radio tuner	Satellite radio tuner communication error. Refer to Satellite Radio Tuner Communication Error

NEXT → END