DTC B1795: Occupant Classification ECU Malfunction: Procedure

1. Turn the ignition switch to ON.
2. Clear the DTCs stored in the occupant classification ECU. Refer to DTC CHECK / CLEAR .
3. Clear the DTCs stored in the center airbag sensor assembly. Refer to DTC CHECK / CLEAR .
4. Turn the ignition switch off.
5. Turn the ignition switch to ON, and wait for at least 10 seconds.
6. Check for DTCs. Refer to DTC CHECK / CLEAR .

   OK

   DTC B1795 is not output.

   HINT: 

   Codes other than B1795 may be output at this time, but they are not related to this check.

NG → See step   2 

OK → See step   4 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Using the Techstream, save the ECU data from the ECU currently installed on the vehicle. Refer to REGISTRATION .
4. Turn the ignition switch off.
5. Disconnect the cable from the negative (-) battery terminal.
6. Replace the occupant classification ECU. Refer to REMOVAL .
7. Connect the cable to the negative (-) battery terminal.
8. Turn the ignition switch to ON.
9. Using the Techstream, load the previous ECU data stored into the new ECU. Refer to REGISTRATION .
10. Turn the ignition switch off.
11. Turn the ignition switch to ON.
12. Clear the DTCs stored in the memory. Refer to DTC CHECK / CLEAR .

    HINT: 

    If the DTCs are not cleared at this time, past DTCs will remain.

NEXT: Go to next step 

1. Perform the sensitivity check. Refer to INITIALIZATION .

NEXT → END