Center Airbag Sensor Communication Stop Mode: Procedure
WARNING: This page is about a different car, the 2011 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR BRANCH WIRE)
- Turn the ignition switch off.
- Disconnect the center airbag sensor assembly connector.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEXT IN ILLUSTRATION*a Front view of wire harness connector:
(to Center Airbag Sensor Assembly) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition E18-13 (CANH) - E18-22 (CANL) Ignition switch off 54 to 69 Ω
NG → REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE)
OK: Go to next step
- CHECK HARNESS AND CONNECTOR (IG2, E1, E2)
- Disconnect the center airbag sensor assembly connector.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEXT IN ILLUSTRATION*a Front view of wire harness connector:
(to Center Airbag Sensor Assembly) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition E18-25 (E1) - Body ground Always Below 1 Ω E18-26 (E2) - Body ground Always Below 1 Ω - Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Switch Condition Specified Condition E18-21 (IG2) - Body ground Ignition switch ON 10 to 14 V
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 3
- Disconnect the center airbag sensor assembly connector.
- REPLACE CENTER AIRBAG SENSOR ASSEMBLY. Refer to REMOVAL