Fail-Safe Chart

WARNING: This page is about a different car, the 2011 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition	Auto Cancel Condition	Re-operation Condition
Cruise main indicator light blinks	There is an open or a short in the stop light switch circuit There is a problem with the vehicle speed signal	Turn the cruise control main switch on again
Cruise main indicator light goes off	There is a problem with the throttle position sensor and motor	Turn the cruise control main switch on again
Cruise main indicator light blinks	There is a problem with the input circuit of the stop light switch circuit There is a problem with the cancel circuit	Turn the cruise control main switch on again Turn the ignition switch off then ON again
Cruise main indicator light remains on (Cruise control is canceled)	Under the following conditions, the stored vehicle speed is maintained: The Vehicle speed is lower than the low speed limit (approx. 40 km/h (25 mph)) while running with the cruise control on The VSC system is operated	Push the cruise control main switch to + (ACCEL)/RES (RESUME)
	The Vehicle speed is lower than the stored speed by approx. 16 km/h (10 mph) or more	Push the cruise control main switch to - (COAST)/SET