Cruise SET Indicator Light Circuit: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Check the SET indicator light by performing the Active Test.
   COMBINATION METER ASSEMBLY
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. SET	SET indicator light	OFF or ON	Confirm that the vehicle is stopped with the engine idling

   OK

   The SET indicator light on or goes off according to Techstream operation.

NG → See step   3 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Cruise Control / Data List.
5. According to the display on tester, read the Data List.
   CRUISE CONTROL (ECM)
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   SET/COAST Switch	- (COAST)/SET switch / ON or OFF	ON: - (COAST)/SET switch on OFF: - (COAST)/SET switch off	-

   OK

   The display changes as shown above according to cruise control main switch operation.

   Result

   Result	Proceed to
   OK	A
   NG (for 2ZR-FE)	B
   NG (for 2AZ-FE)	C

B → See step   5 

C → See step   6 

A → See step   4