Typical Enabling Conditions
WARNING: This page is about a different car, the 2011 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
MANUAL TRANSAXLE MODELS
| Monitor runs whenever following DTCs not present | None |
| Ignition switch | ON |
| Battery voltage | 8 V or more |
| Starter | Off |
| Idle | On |
| Fuel-cut | On |
AUTOMATIC TRANSAXLE MODELS
| Monitor runs whenever following DTCs not present | None |
| Ignition switch | ON |
| Battery voltage | 8 V or more |
| Starter | Off |
| Throttle position sensor circuit fail (P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135) | Not detected |
| Either of the following conditions is met | Condition A or B |
| A. All of the following conditions are met | - |
| Engine coolant temperature | 20°C (68 °F) or more |
| Engine coolant temperature sensor circuit fail (P0115, P0117, P0118, P0125) | Not detected |
| Time after park/neutral position switch on to off | 10 seconds or more |
| B. All of the following conditions are met | - |
| Engine coolant temperature | Less than 20°C (68 °F) |
| Engine coolant temperature sensor circuit fail (P0115, P0117, P0118, P0125) | Detected |
| Time after park/neutral position switch on to off | 30 seconds or more |