Inspection Procedure: Procedure
WARNING: This page is about a different car, the 2011 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Main Body / Data List.
- Read the display on the Techstream.MAIN BODY (MAIN BODY ECU)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note D-Door Lock Pos SW Driver side door lock position switch signal/ON or OFF ON: Driver side door unlocked
OFF: Driver side door locked- P-Door Lock Pos SW Front passenger side door lock position switch signal/ON or OFF ON: Front passenger side door unlocked
OFF: Front passenger side locked- RL-Door Lock Pos SW Rear door lock position switch LH signal/ON or OFF ON: Rear door LH or RH unlocked
OFF: Rear door LH and RH locked- RR-Door Lock Pos SW Rear door lock position switch RH signal/ON or OFF ON: Rear door LH or RH unlocked
OFF: Rear door LH and RH locked- OK
Normal conditions listed above are displayed.
NG → See step 3
OK → See step 2
- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- GO TO POWER DOOR LOCK CONTROL SYSTEM. Refer to PROBLEM SYMPTOMS TABLE