Service Data
WARNING: This page is about a different variant/trim than selected.
| Starter assembly | Standard current | Below 90 A at 11.5 V |
| Starter relay | Standard resistance 3 - 5 |
Below 1 Ω (battery voltage is applied to terminals 1 and 2) |
| 10 kΩ or higher (battery voltage is not applied to terminals 1 and 2) | ||
| Acc relay | Standard resistance 3 - 5 |
Below 1 Ω (battery voltage is applied to terminals 1 and 2) |
| 10 kΩ or higher (battery voltage is not applied to terminals 1 and 2) | ||
| Ignition switch | Standard resistance Between all terminals |
10 kΩ or higher (LOCK) |
| Standard resistance 2 - 3 |
Below 1 Ω (ACC) |
|
| Standard resistance 2 - 3 |
Below 1 Ω (ON) |
|
| Standard resistance 2 - 4 |
||
| Standard resistance 6 - 7 |
||
| Standard resistance 1 - 2 |
Below 1 Ω (START) |
|
| Standard resistance 1 - 4 |
||
| Standard resistance 6 - 7 |
||
| Standard resistance 6 - 8 |
||
| Starter armature assembly resistance | Segment - Segment | Below 1 Ω |
| Commutator - Armature coil | 10 kΩ or higher | |
| Starter armature assembly commutator diameter | Standard diameter | 29.0 mm (1.14 in.) |
| Minimum diameter | 28.0 mm (1.10 in.) | |
| Starter armature assembly commutator circle runout | Standard runout | 0.02 mm (0.000787 in.) |
| Maximum runout | 0.05 mm (0.00197 in.) | |
| Starter armature assembly commutator undercut depth | Standard undercut depth | 0.7 mm (0.0276 in.) |
| Minimum undercut depth | 0.2 mm (0.00787 in.) | |
| Starter brush holder assembly Brush length | Standard length | 14.4 mm (0.567in.) |
| Minimum length | 9.0 mm (0.354 in.) | |
| Starter brush holder assembly resistance | Standard resistance Positive brush holder - Negative brush holder |
10 kΩ or higher |
| Standard resistance Positive brush holder - Positive brush holder Negative brush holder - Negative brush holder |
Below 1 Ω | |
| Stater magnetic switch assembly resistance | Terminal 50 - Terminal C | Below 1 Ω |
| Terminal 50 - Switch body | Below 2 Ω |