DTC 01-DD: Master Reset; DTC 01-E1: Voice Processing Device ON Error: Description
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| 01-DD *1 |
The device that should be the master has been disconnected after the engine starts. |
|
| 01-E1 *2 |
The AMP device stores that the AMP output does not function even while the source device operates. |
HINT:
- *1: If the ignition switch is turned off after idling for 60 seconds, this DTC may be stored when the engine is started again.
- *2: Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.
NOTE:
- Before starting troubleshooting, be sure to clear the DTCs stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
- The radio receiver assembly is the master unit.
- Be sure to clear and recheck for DTCs after the inspection is completed to confirm that no DTCs are output.