Camshaft Position Sensor: Removal: Removal

HINT: 

Although the part name refers to the No. 1 crank position sensors, this procedure is for the camshaft position sensors.

1. REMOVE NO. 2 CYLINDER HEAD COVER  . Refer to REMOVAL - Step 10
2. REMOVE NO. 1 CRANK POSITION SENSOR 
   1. Exhaust camshaft side:
      1. Disconnect the duty vacuum switching valve connector and 3 engine wire harness clamps.
         Fig 1: Locating Engine Wire Harness Clamps

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Disconnect the No. 1 crank position sensor connector.
         Fig 2: Locating No. 1 Crank Position Sensor Connector

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Remove the bolt and No. 1 crank position sensor.
         Fig 3: Locating Camshaft Position Sensor Bolt (For Exhaust Camshaft Side)

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Intake camshaft side:
      1. Disconnect the No. 1 crank position sensor connector.
         Fig 4: Locating No. 1 Crank Position Sensor Connector

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Remove the bolt and No. 1 crank position sensor.
         Fig 5: Locating Camshaft Position Sensor Bolt (For Intake Camshaft Side)

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002