LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2012 >> Matrix Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Wireless Door Lock Control System (Diagnostics - Introduction)) >> Wireless Door Lock Control System >> Data List / Active Test >> Data List / Active Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test

WARNING: This page is about a different car, the 2011 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.
  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Enter the following menus: Body / Main Body / Data List.
    5. Read the Data List according to the display on the Techstream.
      MAIN BODY ECU

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Key Unlock Warning SW Unlock warning switch / ON or OFF ON: Ignition key is inserted
      OFF: Ignition key is not inserted      		 -
      Wireless Control Wireless door lock control function / ON or OFF ON: Operating
      OFF: Not operating      		 -
      Hazard Answer Back Hazard answer-back of wireless / ON or OFF ON: Operating
      OFF: Not operating      		 -
      Wireless Auto Lock Automatic lock function / ON or OFF ON: Operating
      OFF: Not operating      		 -
      Open Door Warning Open door warning / ON or OFF ON: Operating
      OFF: Not operating      		 -
      Auto Lock Time Automatic lock time / 30 s, 60 s or 120 s 30 s: 30 seconds
      60 s: 60 seconds
      120 s: 120 seconds      		 -
      Unlock 2 Operation Wireless unlock function / ON or OFF ON: All doors unlock when UNLOCK switch is pressed twice
      OFF: All doors unlock when UNLOCK switch is pressed once      		 -
      Panic Function Panic function / ON or OFF ON: Operating
      OFF: Not operating      		 -
  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Enter the following menus: Body / Main Body / Active Test.
    5. Perform the Active Test according to the display on the Techstream.
      MAIN BODY ECU

      Tester Display Test Part Control Range Diagnostic Note
      Hazard Turn signal flasher relay ON/OFF Observe headlight and rear combination light for correct operation
      Vehicle Horn Vehicle horns ON/OFF -
      Illuminated Entry System Interior light (Interior light switch is in DOOR position and all doors are closed) ON/OFF -
      Wireless Buzzer Wireless door lock buzzer ON/OFF -
scientia non olet · About LEMON Manuals