Steering Pad Switch: Installation: Installation

WARNING: This page is about a different car, the 2012 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING PAD SWITCH LH
1. for Type A:
  1. Engage the 2 pins and install the steering pad switch LH.
  2. Install the screw.
    Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  3. Engage the clamp.
  4. Connect the connector to the spiral cable.
2. for Type B:
  1. Engage the 2 pins and claw to install the steering pad switch LH.
  2. Install the screw.
    Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  3. Connect the connector to the spiral cable.
INSTALL STEERING PAD SWITCH ASSEMBLY
1. for Type A:
  1. Engage the 2 pins and install the steering pad switch assembly.
  2. Install the screw.
    Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  3. Engage the clamp.
  4. Engage the 2 pins and install the steering pad switch.
  5. Install the screw.
    Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  6. Engage the clamp.
  7. Connect the connector to the spiral cable.
2. for Type B:
  1. Engage the 2 pins and claw to install the steering pad switch assembly.
  2. Install the screw.
    Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  3. Engage the 2 pins and claw to install the steering pad switch.
  4. Install the screw.
    Torque: 2.4 N*m (24 kgf*cm, 21 in.*lbf)
  5. Connect the connector to the spiral cable.
INSTALL STEERING PAD . Refer to INSTALLATION - Step 1
INSTALL LOWER NO. 3 STEERING WHEEL COVER . Refer to INSTALLATION - Step 2
INSTALL LOWER NO. 2 STEERING WHEEL COVER . Refer to INSTALLATION - Step 3
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT STEERING PAD . Refer to INSTALLATION - Step 5
INSPECT SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM