How To Proceed With Troubleshooting

WARNING: This page is about a different car, the 2011 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The wireless door lock control system troubleshooting procedure is based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system. Refer to HOW TO PROCEED WITH TROUBLESHOOTING .

Use this procedure to troubleshoot the wireless door lock control system.

VEHICLE BROUGHT TO WORKSHOP
NEXT: Go to next step
CUSTOMER PROBLEM ANALYSIS
1. Interview the customer to confirm the problem. Refer to HOW TO PROCEED WITH TROUBLESHOOTING .
  NEXT: Go to next step

DTC CHECK

Check for DTCs and note any codes that are output.
Clear the DTCs.

Recheck for DTCs.

Result

Result	Proceed to
DTC is not output	A
DTC is output	Refer to DTC CHECK / CLEAR

A: Go to next step

SYMPTOM SIMULATION
NEXT: Go to next step

PROBLEM SYMPTOMS TABLE

Refer to PROBLEM SYMPTOMS TABLE .

Result

Result	Proceed to
Fault is not listed in problem symptoms table	A
Fault is listed in problem symptoms table	B

B → Go to step 7

A: Go to next step

PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
1. Refer to TERMINALS OF ECU .
2. Refer to DATA LIST / ACTIVE TEST .
  NEXT: Go to next step
ADJUST, REPAIR OR REPLACE
NEXT: Go to next step
CONFIRMATION TEST
NEXT → END