Data List / Active Test
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY
- Turn the ignition switch off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON and turn the Techstream on.
- Enter the following menus: Body Electrical / SRS Airbag / Data List.
- Check the values by referring to the table below.DATA LIST
Tester Display Measurement Item/Range Normal Condition Diagnostic Note Driver Seat Position Driver seat position/
Forward: Seat position is forward
Bkward: Seat position is backward
FAIL: Failure detectedForward/Bkward - Passenger Classification Passenger classification/
NG: Data is not determined
OFF: Vacant
CHILD: Child (less than 36 kg (79.3 lb)) is seated
AF05: Adult (36 to 54 kg (79.3 to 119.0 lb) is seated
AM50: Adult (more than 54 kg (119.0 lb)) is seatedOFF/CHILD/AF05/AM50 - Left Side Buckle SW Left side buckle switch/
Unset: The seat belt is not fastened
Set: The seat belt is fastened
NG: Data is not determinedUnset/Set - Right Side Buckle SW Right side buckle switch/
Unset: The seat belt is not fastened
Set: The seat belt is fastened
NG: Data is not determinedUnset/Set - Number of Past DTC Number of past DTC/
Min.: 0, Max.: 2550 - Display Type Information Display type information/
LR: The display is indicated by LH/RH
DP: The display is indicated by Driver/PassengerLR -