Crankshaft Position Sensor: Installation: Installation

WARNING: This page is about a different car, the 2011 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CRANK POSITION SENSOR
1. Apply a light coat of engine oil to the O-ring on the crank position sensor.
  
  Fig 1: View Of Crankshaft Position Sensor O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the crank position sensor with the bolt.
  
  Fig 2: Remove/Install Crankshaft Position Sensor Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 10 N*m (102 kgf*cm, 7.4 ft.*lbf)
3. Connect the crank position sensor connector.
INSPECT FOR OIL LEAK
INSTALL ENGINE UNDER COVER RH