Intake Manifold: Installation: Installation

WARNING: This page is about a different car, the 2012 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL INTAKE MANIFOLD
1. Using a "TORX" socket wrench (E6), install the 2 stud bolts to the intake manifold.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
2. Install the wire harness clamp bracket with the bolt.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
3. Install a new gasket to the intake manifold.
4. Install the intake manifold and intake manifold stay with the 4 bolts and 2 nuts.
  Bolt
  
  Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)
  
  Nut
  
  Torque: 28 N*m (286 kgf*cm, 21 ft.*lbf)
5. Connect the fuel vapor feed hose, ventilation hose and vacuum hose to the intake manifold.
6. Install the wire harness clamp bracket with an engine cover joint.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
7. Install the engine cover joint.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
8. Connect the 5 wire harness clamps.
INSTALL THROTTLE BODY ASSEMBLY
Refer to INSTALLATION