Front Speed Sensor: Removal: Removal

WARNING: This page is about a different car, the 2011 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
If the sensor rotor needs to be replaced, replace it together with the front drive outboard joint shaft assembly (for TMC Made).
If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly (except TMC Made).

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT WHEEL
REMOVE SIDE MUDGUARD . Refer to REMOVAL - Step 1
REMOVE FRONT FENDER LINER . Refer to REMOVAL - Step 6
REMOVE FRONT SPEED SENSOR (except TMC Made)
1. Disconnect the front speed sensor connector.
  
  Fig 1: Locating Front Speed Sensor Connector And Wire Harness Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the front speed sensor wire harness clamp from the body.
3. Remove the bolt and the No. 2 sensor clamp from the body.
  
  Fig 2: Locating No. 2 Sensor Clamp Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the bolt and separate the brake flexible hose.
  
  Fig 3: Locating Brake Flexible Hose Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the No. 1 sensor clamp from the shock absorber.
  
  Fig 4: Identifying No. 1 Sensor Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the clamp from the shock absorber.
  
  Fig 5: Locating Shock Absorber Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the bolt and the front speed sensor.
  
  Fig 6: Locating Front Speed Sensor Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Prevent foreign matter from attaching to the sensor tip.
  - Clean the installation hole and the surface for the front speed sensor every time the front speed sensor is removed.
REMOVE FRONT SPEED SENSOR (for TMC Made)
1. Disconnect the front speed sensor connector.
  
  Fig 7: Locating Front Speed Sensor Connector And Wire Harness Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the front speed sensor wire harness clamp from the body.
3. Remove the bolt and the No. 2 sensor clamp from the body.
  
  Fig 8: Locating No. 2 Sensor Clamp Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the bolt and separate the brake flexible hose.
  
  Fig 9: Locating Brake Flexible Hose Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the No. 1 sensor clamp from the shock absorber.
  
  Fig 10: Identifying No. 1 Sensor Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the bolt and the front speed sensor.
  
  Fig 11: Locating Front Speed Sensor Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Prevent foreign matter from attaching to the sensor tip.
  - Clean the installation hole and the surface for the front speed sensor every time the front speed sensor is removed.