Confirmation Driving Pattern
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and turn the Techstream on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
- Turn the power switch off.
- Connect the charging cable, plug-in charge the vehicle for at least 30 minutes, and then disconnect the charging cable.
- Turn the power switch on (IG) and turn the Techstream on.
- Enter the following menus: Powertrain / Plug-in Control / Trouble Codes.
- Check that the permanent DTCs are cleared.
- If the permanent DTCs are not cleared, perform a universal trip, and then check for permanent DTCs again.
HINT:
- If a permanent DTC is output, the system is malfunctioning.
- If no permanent DTC is output, the system is normal.