DTC P2511-441: Reset Detected: Procedure
- CHECK DTC OUTPUT (PLUG-IN CONTROL)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Enter the following menus: Powertrain / Plug-in Control / Trouble Codes.
- Check if DTCs are output.
Result
Result Proceed to P2511-441 only is output. A DTCs other than P2511-441 is output. B - Turn the power switch off.
B → See step 5
A: Go to next step
- CHECK AUXILIARY BATTERY TERMINAL (CONTACT PROBLEM)
- Check the connection of the auxiliary battery terminal.
OK
The terminal is connected securely and there is no contact problem.
NG → CONNECT SECURELY
OK: Go to next step
- Check the connection of the auxiliary battery terminal.
- CHECK FOR ECU POWER SOURCE CIRCUIT
Refer to ECU Power Source Circuit
NG → REPAIR OR REPLACE MALFUNCTIONING PARTS, COMPONENT AND AREA
OK: Go to next step
- CHECK FOR INTERMITTENT PROBLEMS
- Check for intermittent problems. Refer to CHECK FOR INTERMITTENT PROBLEMS
.
Result
Result Proceed to Problem symptom does not recur. A Problem symptom recurs. B
B → REPAIR OR REPLACE MALFUNCTIONING PARTS, COMPONENT AND AREA
A → See step 6
- Check for intermittent problems. Refer to CHECK FOR INTERMITTENT PROBLEMS
.
- GO TO DTC CHART (PLUG-IN CHARGE CONTROL SYSTEM). Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPLACE PLUGIN CHARGE CONTROL ECU ASSEMBLY. Refer to COMPONENTS