Charging Stops during Plug-in Charging: Procedure

CHECK DTC OUTPUT (HEALTH CHECK)

Check DTCs.

Result

Result	Proceed to
No DTCs are output.	A
DTCs are output.	B

B → GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART

A: Go to next step

READ VALUE USING TECHSTREAM (CHARGE CANCEL HISTORY)

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Plug-in Control / Utility / Charge Cancel History.

Check for Charge Cancel History.

Result

Result	Proceed to
A "Charge Cancel History" listed in the following table is not output.	A
A "Charge Cancel History" listed in the following table is output.	B

Charge Cancel History
Charges Canceled (Charge Connector Not Engaged Properly)
Charges Canceled (Power Failure)
Charges Canceled (AC Line)
Charges Canceled (CCID Relay)
Charges Canceled (Nonstandard Cable)
Charges Canceled (Battery Temperature)
Charges Canceled (Rated Electricity Power Supply)
Charges Canceled(+B)
Charges Canceled(System)

B → See step 4

A: Go to next step

CAUSE ANALYSIS

Perform cause analysis in the order of "Vehicle", "Environment" and "User" categories as specified in the following tables.

VEHICLE

Possible Cause	Action to be Taken
-	-

ENVIRONMENT

Possible Cause	Action to be Taken
-	-

USER

Possible Cause	Action to be Taken
The power switch was turned on (READY) during plug-in charging.	Interview customer and provide instruction on usage.
The charging cable was disconnected.	Interview customer and provide instruction on usage. When the charging cable is disconnected properly, the plugin charge control ECU assembly does not store any "Charge Cancel History". However, "CHARGE STOPPED DUE TO CHARGE CONNECTOR OPERATION" is displayed on the multi-information display when the next time the power switch is turned on (IG).

NEXT → END