LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2012 >> Prius Plug-in >> Repair and Diagnosis (Single Page) >> Restraints >> Restraints Control Systems >> Supplemental Restraint System (Plug-In) (Service Information) >> Front Seat Side Airbag Assembly >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Seat Side Airbag Assembly: Installation: Installation

  1. INSTALL FRONT SEAT AIRBAG ASSEMBLY 
    WARNING:
    • The nuts must not be reused.
    • Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.
    1. Install the front seat airbag assembly with 2 new nuts.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

    2. Engage the 2 clamps.
  2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD 

    for Manual Seat: Refer to REASSEMBLY - Step 14

    for Power Seat: Refer to REASSEMBLY - Step 9

  3. CONNECT FRONT SEAT AIRBAG ASSEMBLY 
    1. Engage the clamp and connect the seat heater wire harness connector.
    2. Engage the fastener to secure the airbag wire harness.
    3. Connect the airbag wire harness to the seat clamp.
    4. Engage the claw and 3 clamps to install the airbag wire harness.
    5. Connect the rubber band.
  4. INSTALL FRONT SEAT ASSEMBLY 

    for Manual Seat: Refer to INSTALLATION

    for Power Seat: Refer to INSTALLATION

  5. PERFORM DIAGNOSTIC SYSTEM CHECK 

    Refer to DTC CHECK / CLEAR

scientia non olet · About LEMON Manuals