DTC P0111: Intake Air Temperature Sensor Gradient Too High: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0111)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.
Result
Result Proceed to DTC P0111 and other DTCs are output A DTC P0111 is output B HINT:
If any DTCs other than P0111 are output, troubleshoot those DTCs first.
B → See step 3
A → See step 2
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPLACE MASS AIR FLOW METER SUB-ASSEMBLY. Refer to REMOVAL