Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| Monitor runs whenever following DTCs are not present | None |
| Hybrid control module judge | Engine running |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 1)
| Time after power switch off to on (IG) | More than 0.5 seconds |
| Lost communication with power management control ECU (U0293) | Not detected |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 2)
| Time after power switch off to on (IG) | More than 0.5 seconds |
| Engine speed | 600 rpm or more |
| Time after starter ON to OFF | 3 seconds or more |
| Lost communication with power management control ECU (U0293) | Not detected |
P0335: CRANKSHAFT POSITION SENSOR RANGE CHECK OR RATIONALITY
| Engine speed signal | Signal input |
| Time after starter OFF to ON | 2.5 seconds or more |
| Camshaft position sensor circuit fail (P0340, P0342, P0343) | Not detected |
| Number of camshaft position sensor signal pulse | 6 times |
| Auxiliary battery voltage | 7 V or more |
| Lost communication with power management control ECU (U0293) | Not detected |