Fail-Safe Chart
WARNING: This page is about a different variant/trim than selected.
HINT:
If the following conditions are detected while cruise control is in operation, the system clears the stored vehicle speed in the hybrid vehicle control ECU and cancels the cruise control operation.
| Vehicle Condition |
Auto Cancel Condition |
Re-operation Condition |
| Cruise main indicator light blinks |
- There is problem with input circuit of stop light switch circuit
- There is problem with cancel circuit
- There is problem with electronically controlled brake system
- There is open or short in stop light switch circuit
- Communication stop between brake booster with master cylinder (skid control ECU) and power management control ECU
- There is problem with hybrid vehicle control system
|
- Turn cruise control main switch on again
- Turn power switch off then on (IG) again
|
| Cruise main indicator light remains on (Cruise control is canceled) |
- Vehicle speed is lower than low speed limit (approximately. 40 km/h (25 mph)) while running with cruise control on
- Electronically controlled brake system operates
|
Push cruise control main switch to + RES |
- Vehicle speed is lower than stored speed by approximately 16 km/h (10 mph) or more
|
Push cruise control main switch to - SET |