LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2012 >> Prius Three >> Repair and Diagnosis (Single Page) >> External Pages >> Different variant/trim >> Section 90 (Brake Control System (Plug-In) (Service Information)) >> Steering Angle Sensor >> Removal >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Angle Sensor: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Do not remove the steering angle sensor from the spiral cable.
  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.
  1. REMOVE STEERING WHEEL ASSEMBLY 

    Refer to REMOVAL

  2. REMOVE LOWER STEERING COLUMN COVER  . Refer to REMOVAL - Step 4
  3. REMOVE UPPER STEERING COLUMN COVER  . Refer to REMOVAL - Step 5
  4. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 
    1. Remove the spiral cable with sensor sub-assembly. Refer to REMOVAL - Step 4 .
      NOTE:
      • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
      • Do not rotate the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
      • Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
      • Do not remove the steering angle sensor from the spiral cable.
scientia non olet · About LEMON Manuals