DTC C1A10: Front Radar Sensor: Procedure

1. Replace the millimeter wave radar sensor. Refer to REMOVAL .

NEXT: Go to next step 

1. Adjust the millimeter wave radar sensor. Refer to ADJUSTMENT .

NEXT: Go to next step 

1. Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
2. Clear the DTCs. Refer to DTC CHECK / CLEAR .
3. Recheck for DTCs.

   OK

   DTC C1A10 is not output.

NG → See step   4 

OK → END