DTC P2610: ECM / PCM Internal Engine Off Timer Performance: Procedure

1. Replace the ECM. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
5. Turn the power switch off and wait for at least 30 seconds.
6. Put the engine in inspection mode (maintenance mode). Refer to INSPECTION MODE PROCEDURE .
7. Start the engine and wait for 10 minutes or more.
8. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
9. If no pending DTC is displayed, the repair has been successfully completed.

NEXT → END