Data List / Active Test
- DATA LIST
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Warm up the engine.
- Turn the power switch off.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus:
- for Combination Meter: Body Electrical / Combination Meter / Data List.
- for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.
- for Engine: Powertrain / Engine and ECT / Data List.
- Check the values by referring to the table below.COMBINATION METER
Tester Display Measurement Item/Range Normal Condition Diagnostic Note Tail Cancel SW Tail cancel switch/OFF or ON OFF: Tail cancel switch off Dimming of dash lights is possible ON: Tail cancel switch on Dimming of dash lights is canceled P-Seatbelt Buckle SW Front passenger side seat belt buckle switch/OFF or ON OFF: Front passenger side seat belt unfastened - ON: Front passenger side seat belt fastened Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 199 km/h (124 mph) Almost the same as actual vehicle speed (Speedometer tester) - Coolant Temperature Engine coolant temperature/-40 to 127.5°C (-40 to 261.5°F) After warming up: 80 to 100°C (176 to 212°F) - Head Up Display Switch (Up) Headup display position up switch/OFF or ON OFF: Headup display position up switch not pressed - ON: Headup display position up switch pressed Head Up Display Switch (Down) Headup display position down switch/OFF or ON OFF: Headup display position down switch not pressed - ON: Headup display position down switch pressed Head Up Display Switch (Main) Headup display main switch/OFF or ON OFF: Headup display main switch not pressed - ON: Headup display main switch pressed Timer Switch M on Combination Meter Minute adjust switch/OFF or ON OFF: Minute adjust switch not pressed - ON: Minute adjust switch pressed Timer Switch H on Combination Meter Hour adjust switch/OFF or ON OFF: Hour adjust switch not pressed - ON: Hour adjust switch pressed Timer Switch 00 on Combination Meter Second adjust switch/OFF or ON OFF: Second adjust switch not pressed - ON: Second adjust switch pressed Check Engine SW Check power switch/OFF or ON OFF: Check power switch off - ON: Check power switch on Light Control Up Switch Headup display light control rheostat up switch/OFF or ON OFF: Headup display light control rheostat up switch not pressed - ON: Headup display light control rheostat up switch pressed Light Control Down Switch Headup display light control rheostat down switch/OFF or ON OFF: Headup display light control rheostat down switch not pressed - ON: Headup display light control rheostat down switch pressed Multi Display Select Switch DISP switch in the multi-information switch (steering pad switch assembly)/OFF or ON OFF: DISP switch in the multi-information switch (steering pad switch assembly) not pressed - ON: DISP switch in the multi-information switch (steering pad switch assembly) pressed Drive Monitor Reset SW TRIP switch in the steering pad switch assembly/OFF or ON OFF: TRIP switch in the steering pad switch assembly not pressed - ON: TRIP switch in the steering pad switch assembly pressed more than 1 second +B Voltage Value Battery voltage/Min.: 0, Max.: 25.5 (V) 11 to 14 V - Fuel Input Fuel input signal/Min.: 0, Max. 127.5 (G) 10th segment comes on: 39.6 to 45.0 - 9th segment comes on: 35.7 to 39.6 8th segment comes on: 31.8 to 35.7 7th segment comes on: 27.9 to 31.8 6th segment comes on: 24.0 to 27.9 5th segment comes on: 20.1 to 24.0 4th segment comes on: 16.2 to 20.1 3rd segment comes on: 12.3 to 16.2 2nd segment comes on: 8.4 to 12.3 1st segment comes on: 6.1 to 8.4 Integrated Value for Oil Maintenance Maintenance required reminder value/Min.: 0, Max.: 25500 (mile) Driving distance after performing maintenance required reminder resetting procedure displayed If the value is 5000 (miles) or more, perform the maintenance required reminder resetting procedure after performing maintenance. Rheostat value Light control rheostat value/Min.: 0, Max.: 100 (%) The light control rheostat value 0% (dark) The value changes with rheostat operation The light control rheostat value 255% (bright) TPMS Operation State The condition of the tire pressure/OFF, ON, or Unknown OFF: Tire pressure warning system not operated - ON: Tire pressure warning system operated Unknown: Wire harness between combination meter assembly and tire pressure warning ECU open Oil Pressure Switch Oil pressure switch/OFF or ON OFF: Engine started - ON: Engine not started Key Remind Sound The customized setting of the key remind buzzer/Normal, Fast, Slow - The customized setting of the key reminder sound displayed Driver Side Seatbelt Warning Buzzer The condition of the driver side seat belt warning buzzer/OFF or ON OFF: The driver side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt unfastened The customized setting of the driver side seat belt warning buzzer is displayed ON: The driver side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt unfastened P-Seatbelt Warning Buzzer The condition of the front passenger side seat belt warning buzzer/OFF or ON OFF: The front passenger side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt unfastened The customized setting of the front passenger side seat belt warning buzzer is displayed ON: The front passenger side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt unfastened Reverse Buzzer The customized setting of the reverse buzzer/Continual or Single Continual: When the shift lever moves to R, buzzer sounds continuously The customized setting of the reverse buzzer displayed Single: When the shift lever moves to R, a single buzzer sounds Number of Trouble Code The number of the DTC which is currently output 0 - ABS/VSC/TRCTester Display Measurement Item/Range Normal Condition Diagnostic Note Vehicle Speed Maximum wheel speed sensor / Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations ENGINE AND ECTTester Display Measurement Item/Range Normal Condition Stored as Freeze Frame Data Coolant Temp Engine coolant temperature/
Min.: -40°C (-40°F), Max.: 140°C (284°F)80 to 100°C (176 to 212°F): After warming up Yes Diagnostic Note:
This is the engine coolant temperature.
HINT:- After warming up the engine, the engine coolant temperature is 80 to 100°C (176 to 212°F).
- After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.
- If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit may be open or shorted.
- Check if the engine overheats when the value indicates higher than 135°C (275°F).
MAIN BODYTester Display Measurement Item/Range Normal Condition Diagnostic Note Illumination Rate Info Illumination rate information/0 ms. to 2162.65 ms. Value is output according to ambient light levels -
- ACTIVE TEST
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the operation by referring to the table below.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Speed Meter Operation Speedometer OFF, 0, 40, 80, 120, 160, 200, 240, 280 mph*1 Confirm that the vehicle is stopped with the engine idling OFF, 0, 40, 80, 120, 160, 200, 240, 280 km/h*2 Fuel Meter Operation Fuel receiver gauge OFF, Empty, 1/2, Full Confirm that the vehicle is stopped with the engine idling Fuel Consumption Meter Operation Fuel consumption meter OFF, MIN, 1/4, 1/2, 3/4, MAX Confirm that the vehicle is stopped with the engine idling A/T Indicator Operation 1 Shift indicator light OFF, L, 2, 3, 4, D, N, R, P Confirm that the vehicle is stopped with the engine idling A/T Indicator Operation 2 Shift indicator light OFF, 8, 5, 6, 7, Es, M, S, B Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Airbag SRS warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Doors All Open Door indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Front Passenger Side Seat Belt Front passenger side seat belt warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Driver Side Seat Belt Driver side seat belt warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp ABS ABS warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Charge Charge warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Slip Slip indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Tire Pressure Warning System Tire pressure warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Coolant Hot Coolant hot temperature warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Beam High beam indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Tail Tail indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Fr FOG Front fog indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Precrash*3 PCS warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Driver Side Door Open Door open warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Front Passenger Side Door Open Door open warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Rear Door RH Open Door open warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Rear Door LH Open Door open warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Back Door Open Door open warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Headlamp Auto Leveling*4 Headlight leveling indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp ECB Electrically controlled brake warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp ECT PWR Power mode indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Cruise Cruise main indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Lamp Brake Brake warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. EPS EPS warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Master Warning Master warning light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Ready (HV) Ready indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. EV Mode EV mode indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. SET Set indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. Radar Cruise*5 Cruise main indicator light (constant speed control mode or vehicle-to-vehicle distance control mode) OFF or ON Confirm that the vehicle is stopped with the engine idling Indicator. ECO MODE ECO mode indicator light OFF or ON Confirm that the vehicle is stopped with the engine idling Meter Display 1 Multi-information display All the dots in the multi-information display OFF or ON Confirm that the vehicle is stopped with the engine idling - *1: for models with mph unit
- *2: for models with km/h unit
- *3: w/ Pre-collision System
- *4: w/ Automatic Headlight Beam Level Control System
- *5: w/ Dynamic Radar Cruise Control System