Blower Unit: Disassembly: Disassembly

WARNING: This page is about a different variant/trim than selected.

REMOVE RECIRCULATION DAMPER SERVO SUB-ASSEMBLY
1. Remove the 2 screws and recirculation damper servo sub-assembly.
  
  Fig 1: Identifying Air Inlet Servo Motor Sub-Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR FILTER CASE
1. Disengage the claw and guide, and remove the air filter case as shown in the illustration.
  
  Fig 2: Removing Air Filter Case
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLEAN AIR FILTER
1. Remove the clean air filter as shown in the illustration.
  
  Fig 3: Removing Clean Air Filter
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER WITH FAN MOTOR SUB-ASSEMBLY
1. Remove the 3 screws and blower with fan motor sub-assembly.
  
  Fig 4: Identifying Front Blower Motor Sub-Assembly Screws (W/ Solar Ventilation System)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  Do not remove the blower with fan motor sub-assembly if it has been damaged or impacted.