Pre-Collision Brake Cancel Switch: Inspection: Inspection
WARNING: This page is about a different variant/trim than selected.
- INSPECT PRE-COLLISION SYSTEM CANCEL SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Standard Resistance
Tester Connection Switch Condition Specified Condition 1 - 2 Pressed Below 1 Ω Not pressed 10 kΩ or higher TEXT IN ILLUSTRATION*a Component without harness connected
(Pre-collision System Cancel Switch Assembly)
- Measure the resistance according to the value(s) in the table below.