Data List / Active Test
WARNING: This page is about a different variant/trim than selected.
- DATA LIST NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- Connect the Techstream to the DLC3.
- Turn the power switch on (READY).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Navigation System / Data List.
- According to the display on the Techstream, read the Data List.NAVIGATION SYSTEM
Tester Display Measurement Item/Range Normal Condition Diagnostic Note Battery Voltage Auxiliary battery voltage/Min.: 0 V, Max.:24 V 11 to 15.5 V - Active Dimmer Active dimmer function/ON or OFF ON: Active dimmer function on
OFF: Active dimmer function off- Tail Light SW Tail light switch/ON or OFF ON: Light control switch in tail or head position
OFF: Light control switch off- Reverse Signal Reverse signal/ON or OFF ON: Reverse selected
OFF: Reverse not selected- Parking Brake Parking brake switch/ON or OFF ON: Parking brake applied
OFF: Parking brake released- Ignition Power switch/ON or OFF ON: Power switch on (IG)
OFF: Power switch off- Vehicle Speed Maximum wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations