Power Source Mode does not Change to ON (ACC): Procedure

CHECK DTC (ALL) See step 1
NG → See step 6

OK: Go to next step
INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (ACC RELAY) See step 3
NG → REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

OK: Go to next step
CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) See step 4
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: Go to next step
INSPECT POWER MANAGEMENT CONTROL ECU See step 5
NG → See step 7

OK: Go to next step
CONFIRMATION TEST See step 8
NG → CHECK RELAY CONTACT CIRCUIT

OK → SYSTEM RETURNED TO NORMAL (PROBLEM OCCURRED DUE TO BAD CONNECTION, BUT RETURNED TO NORMAL BY RECONNECTING CONNECTOR)
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART
REPLACE POWER MANAGEMENT CONTROL ECU. Refer to REMOVAL