Engine Control System (Service Information) (Except Hybrid): ECM: Installation: Installation

1. Install the ECM bracket with the nut.

   Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

2. Connect the 2 wire harness clamps.
3. Install the nut.

   Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

1. Install the No. 2 ECM bracket to the ECM with the 2 screws.

   Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf) 

2. Temporarily install the screw (B).
   Fig 1: Identifying ECM Nut, Screws & Bracket

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the ECM with the nut.

   Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

4. Install the screw (A).

   Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf) 

5. Tighten the screw (B).

   Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf) 

6. Connect the 2 ECM connectors and lower the 2 levers.
   NOTE:

   • When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other part.
   • Make sure that the 2 levers are securely locked.

Refer to PRECAUTION .