Jam Protection Function does not Operate: Procedure

PERFORM INITIALIZATION (DRIVER DOOR WINDOW MOTOR)
1. Initialize the power window regulator motor assembly LH (for driver door). Refer to INITIALIZATION .
NEXT: Go to next step
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (FOR DRIVER DOOR))
1. Check if the power window auto up and down function operate normally. Refer to OPERATION CHECK .
  OK
  
  Driver door auto up and down function is normal.
NG → See step 4

OK: Go to next step
CHECK JAM PROTECTION FUNCTION OPERATING RANGE
1. Check if the jam protection function operates normally for the driver door power window.
  HINT:
  
  The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.
  
  OK
  
  Jam protection function operates normally.
NG → See step 5

OK → END (PROBLEM DUE TO INITIALIZATION FAILURE)
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to PROBLEM SYMPTOMS TABLE
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR). Refer to REMOVAL