ATEQ TPMS Reset Procedure (Direct TPM System)

NOTE: This is a Direct TPM System. Vehicle has pressure sensors installed on the wheels.

NOTE: The system will need to be initialized when tires are rotated; tires are replaced with tires of different pressures; tire pressure sensor and/or tire pressure monitor ECU are replaced. Set tire pressure within the specified range before initializing.

Turn ignition switch to OFF position.
Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
Select "Reset TPM System" on the TPMS3.
Hold the TPMS3 against the side wall of the tire, within 3 inches of the valve stem. Press TEST button on the TPMS3 and read each of the sensor IDs in the following order: left front, right front, right rear, and then left rear. Spare tire may be required.
Connect the TPMS3 OBDII module to the Data Link Connector (DLC) located under the driver's side of the instrument panel.
Turn ignition switch to ON position. Do not start engine.
When screen prompts to "CONNECT OBDII MODULE", press "Y" button on the TPMS3 to transmit sensor IDs.
Use TPMS3 to trigger all 4 or 5 sensors until the TPMS warning indicator light on instrument panel is OFF.
Turn ignition switch to OFF position. Disconnect the TPMS3 from DLC.