LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Corolla Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> Power Steering System (Diagnostics - Introduction) >> Power Steering System >> DTC Check / Clear >> DTC Check / Clear
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Check / Clear

  1. CHECK DTCs 
    1. Turn the ignition switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the ignition switch on (IG).
    4. Turn the Techstream on.
    5. Read the DTCs following the display on the Techstream. Enter the following menus: Chassis / EMPS / Trouble Codes.
    6. Refer to the Diagnostic Trouble Code Chart for DTC information. Refer to DIAGNOSTIC TROUBLE CODE CHART.
  2. CLEAR DTCs 
    1. Turn the ignition switch off.
    2. Connect the Techstream to the DLC3.
    3. Start the engine.
    4. Turn the Techstream on.
    5. Clear the DTCs following the display on the Techstream. Enter the following menus: Chassis / EMPS / Trouble Codes.
    6. According to the display on the Techstream, select the trouble code data display with the clear button.
    7. Turn the ignition switch off.
    8. Disconnect the Techstream from the DLC3.
scientia non olet · About LEMON Manuals