DTC P2111: Throttle Actuator Control System - Stuck Open; DTC P2112: Throttle Actuator Control System - Stuck Closed: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
5. Read the DTCs.

   Result

   Result	Proceed to
   DTC P2111 or P2112 is output	A
   DTC P2111 or P2112 and other DTCs are output	B

   HINT: 

   If any DTCs other than P2111 or P2112 are output, troubleshoot those DTCs first.

B → See step   7 

A: Go to next step 

1. Check for contamination between the throttle valve and the housing. If necessary, clean the throttle with motor body assembly. And check that the throttle valve moves smoothly.

   OK

   Throttle valve is not contaminated with foreign objects and moves smoothly.

NG → See step   5 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
5. Turn the ignition switch off and wait for at least 30 seconds.
6. Turn the ignition switch to ON.
7. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Position No. 1, Throttle Position No. 2 and Throttle Position Command.
8. Check the values displayed on the Techstream while wiggling the ECM wire harness.
9. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
10. Check for DTCs.

    Result

    Result	Proceed to
    Value in Data List changes when wire harness is wiggled, or DTC is output	A
    Other than above	B

B → See step   6 

A: Go to next step 

1. As the DTC was stored due to a change in the contact resistance of the connector, repair or replace the wire harness or connector. Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE .

NEXT → END 

1. Replace the throttle body assembly. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
5. Start the engine, and fully depress and release the accelerator pedal quickly (to fully open and close the throttle valve).
6. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
7. Read DTCs.

   Result

   Result	Proceed to
   DTC is not output	A
   DTC P2111 or P2112 is output	B

B → See step   8 

A → END