Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| Monitor runs whenever following DTCs not stored | None |
P0335: CRANKSHAFT POSITION SENSOR RANGE CHECK/RATIONALITY
| Time after starter off to on | 3 seconds or more |
| Number of camshaft position sensor signal pulses | 6 times |
| Battery voltage | 7 V or higher |
| Minimum battery voltage while starter on | Less than 11 V |
| Camshaft position sensor circuit fail | Not detected |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 1)
| Starter | Off |
| Engine speed | 600 rpm or more |
| Time after starter from on to off | 3 seconds or more |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 2)
| Starter | On |
| Minimum battery voltage while starter on | Less than 11 V |