Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| Monitor runs whenever following DTCs are not present | P0010 (VVT Oil Control Valve) P0011 (VVT System - Advance) P0012 (VVT System - Retard) P0016 (VVT System - Misalignment) P0031, P0032 (Air Fuel Ratio Sensor Heater - Sensor 1) P0037, P0038 (Heated Oxygen Sensor Heater - Sensor 2) P0102, P0103 (Mass Air Flow Meter) P0115, P0117, P0118 (Engine Coolant Temperature Sensor) P0120, P0121 P0122, P0123, P0220, P0222, P0223, P2135 (Throttle Position Sensor) P0125 (Insufficient Engine Coolant Temperature for Closed Loop Fuel Control) P0136, P0137, P0138, P0139 (Oxygen sensor - Sensor 2) P014C, P014D, P015A, P015B, P2195, P2196, P2237, P2238, P2239, P2252, P2253 (Air Fuel Ratio Sensor - Sensor 1) P0171, P0172 (Fuel System) P0301, P0302, P0303, P0304 (Misfire) P0335 (Crankshaft Position Sensor) P0340 (Camshaft Position Sensor) P0351, P0352, P0353, P0354 (Igniter) P0500 (Vehicle Speed Sensor) P0607 (Heated Oxygen Sensor - Sensor 2) |
| Battery voltage | 11 V or more |
| Intake air temperature | -10°C (14°F) or more |
| Engine coolant temperature | 75°C (167°F) or more |
| Atmospheric pressure | 76 kPa(abs) (570 mmHg(abs)) or more |
| Idle | Off |
| Engine speed | Less than 4000 rpm |
| Air fuel ratio sensor | Activated |
| Fuel system status | Closed loop |
| Engine load | 10% or more, and less than 80% |
| All of the following conditions are met | Condition 1, 2 and 3 |
| 1. Mass air flow rate | 2.5 g/sec or more, and less than 50 g/sec |
| 2. Front catalyst temperature (estimated) | 620°C (1148°F) or more, and less than 840°C (1544°F) |
| 3. Rear catalyst temperature (estimated) | 400°C (752°F) or more, and less than 770°C (1418°F) |
| Shift position | Automatic transaxle: 4th or higher Manual transaxle: 3rd or higher |