Noise Occurs from Generator while Engine is Running: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK LOOSENESS OF V-RIBBED BELT
- Check the tension of the belt by pushing it down with a finger.
OK
The tension of the belt is enough.
NG → See step 5
OK: Go to next step
- Check the tension of the belt by pushing it down with a finger.
- CHECK V-RIBBED BELT FOR WEAR
- Check the V-ribbed belt for wear.
OK
The V-ribbed belt is not worn.
NG → See step 6
OK: Go to next step
- Check the V-ribbed belt for wear.
- CHECK CLUTCH PULLEY FOR WEAR
- Check the clutch pulley groove for wear or other defects.
OK
The clutch pulley groove is not damaged.
NG → See step 7
OK: Go to next step
- Check the clutch pulley groove for wear or other defects.
- CHECK FOR NOISE WHILE CLUTCH PULLEY IS OPERATING
- Perform a driving test and check if noise occurs when decelerating.
OK
Noise does not occur.
NG → See step 7
OK → See step 8
- Perform a driving test and check if noise occurs when decelerating.
- REPLACE V-RIBBED BELT TENSIONER ASSEMBLY. Refer to COMPONENTS
- REPLACE V-RIBBED BELT. Refer to COMPONENTS
- REPLACE CLUTCH PULLEY. Refer to COMPONENTS
- REPLACE GENERATOR ASSEMBLY. Refer to COMPONENTS