Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
MANUAL TRANSAXLE MODELS
| Monitor runs whenever following DTCs are not present | None |
| Time after ignition switch off to ON | 3 seconds or more |
| Starter | Off |
| Battery voltage | 8 V or more |
| Idle | On |
| Fuel cut | On |
AUTOMATIC TRANSAXLE MODELS
| Monitor runs whenever following DTCs are not present | None |
| Time after ignition switch off to ON | 3 seconds or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | Off |
| Engine | Running |
| Intermediate shaft speed sensor revolution | 300 rpm or more |
| Either of the following conditions is met | Condition A or B |
| A. All of the following conditions are met | - |
| Engine coolant temperature | 20°C (68°F) or higher |
| Engine coolant temperature sensor fail (P0115, P0117, P0118, P0125) | Not detected |
| Time after park/neutral position switch turned from on to off | 2 seconds or more |
| B. Both of the following conditions are met | Conditions 1 and 2 |
| 1. Either of the following conditions is met | Condition (a) and (b) |
| (a) Engine coolant temperature | Below 20°C (68°F) |
| (b) Engine coolant temperature sensor fail (P0115, P0117, P0118, P0125) | Detected |
| 2. Time after park/neutral position switch turned from on to off | 30 seconds or more |