DTC P0617: Starter Relay Circuit High: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.
5. Read the value displayed on the Techstream when the vehicle is driven at 12 mph (20 km/h) or more.
   WARNING:

   When performing the confirmation driving pattern, obey all speed limits and traffic laws.

   Result

   Condition	Result	Proceed to
   Driving at 12 mph (20 km/h) or more	OFF (Starter signal off)	A
   	ON (Starter signal on) (Automatic transaxle models)	B
   	ON (Starter signal on) (Manual transaxle models)	C

B → See step   2 

C → See step   4 

A → See step   7 

1. Inspect the park/neutral position switch assembly. Refer to INSPECTION for 2WD. Refer to INSPECTION for 4WD).

   Result

   Result	Proceed to
   OK	A
   NG (for 2WD)	B
   NG (for 4WD)	C

B → See step   8 

C → See step   11 

A: Go to next step 

1. Repair or replace harness or connector (park/neutral position switch assembly - ST relay - ECM).

NEXT → See step   6 

1. Inspect the ignition switch. Refer to INSPECTION .

NG → See step   9 

OK: Go to next step 

1. Repair or replace harness or connector (ignition switch - ST relay - ECM)

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
5. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
6. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
7. Read the DTCs.

   Result

   Result	Proceed to
   P0617	A
   No output	B

B → END 

A → See step   10