Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL (CASE 1 AND CASE 2)
| Monitor runs whenever following DTCs not stored | None |
| Either of following conditions met: | 1 or 2 |
| 1. Ignition switch | ON |
| 2. Throttle actuator power | ON |
| Accelerator pedal position sensor circuit fail (P2120, P2122, P2123, P2125, P2127, P2128, P2138) | Not detected |
CASE 2
| VPA2 voltage | Less than 4.84 V |
| Either of following conditions met: | a or b |
| a) VPA voltage - Learned VPA accelerator off position voltage | 0.04 V or higher |
| b) VPA2 voltage - Learned VPA2 accelerator off position voltage | 0.04 V or higher |