LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Matrix Base, Automatic Trans >> Repair and Diagnosis >> Maintenance >> Procedures >> Maintenance Reminder Light (Reset Procedures) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 19 >> Sensor Registration
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sensor Registration

NOTE: When a tire pressure sensor and/or tire pressure monitor ECU are replaced, the sensor ID must be memorized (registered) by the tire pressure monitor ECU prior to system initialization. The ID codes can be registered in the SETTINGS DISPLAY (gear icon) of the multi-information display.
  1. Select SETTINGS DISPLAY (gear icon) on the multi-information display using the meter control switches on the steering wheel. See Figure.
  2. Select VEHICLE INFORMATION and then press and hold OK.
  3. Select TPWS and then press OK.
  4. Select CHANGE WHEEL then press and hold OK until the tire pressure warning light blinks slowly 3 times.
    NOTE: A message will then be displayed on the multi-information display. "---" will be displayed on the multi-information display for the inflation pressure of each tire while initialization is being performed.
  5. Drive straight (with occasional left and right turns) at approximately 25 mph (40 km/h) or more for approximately 10 to 30 minutes.
  6. Registration is complete when the tire pressure warning light turns off and the inflation pressure of each tire is displayed on the multiinformation display.
    NOTE: Initialization may take longer than approximately 1 hour in certain situations, such as when the vehicle is stopped for a long time at traffic lights, etc.
scientia non olet · About LEMON Manuals