EPS Warning Light Circuit: Procedure

1. Check for DTCs.

   OK

   DTC is not output.

NG → See step   4 

OK: Go to next step 

1. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC is not output.	A
   DTC C1551 or C1552 is output.	B

B → See step   5 

A: Go to next step 

1. Check the combination meter assembly condition.
   1. Turn the ignition switch to ON.
   2. Check that the P/S warning light comes on for 3 seconds after the ignition switch is turned to ON.

      OK

      The combination meter assembly operates normally.

NG → See step   4 

OK → See step   6