Remove & Install or Remove & Replace
WARNING: This page is about the Matrix Base, Automatic Trans, which is a different variant/trim than selected.
DOES NOT include alignment.
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both | DOES NOT include wheel alignment. | 2.9 | 1.8 | B |
| Left Side | DOES NOT include wheel alignment. | 1.7 | 1.3 | B |
| Right Side | DOES NOT include wheel alignment. | 1.9 | 1.3 | B |
| Combination Procedure: AXLE SHAFT: Replace: NOTE: For Independent Suspension Type Axles, this operation consists of dissassembly and reassembly of the Axle Shaft Assembly and replacement of the Axle Shaft. | ||||
| Each | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT BOOT: Remove & Replace: | ||||
| Inner & Outer,Each Side | 1.0 | B | ||
| Combination Procedure: AXLE SHAFT CENTER SUPPORT BEARING: Remove & Replace: | ||||
| 0.7 | B | |||
| Combination Procedure: CONSTANT VELOCITY JOINT: Remove & Replace: | ||||
| Each | 0.5 | B | ||
| Combination Procedure: TRANSAXLE OUTPUT SEAL: Remove & Replace: | ||||
| Each | 0.2 | B | ||