TPMS Reminder Reset - Procedure 17: Notes

NOTE: For Sequoia, this procedure applies to vehicles from September 2007 and later. For Sequoia models from 2005 up to August 2007, see PROCEDURE 07 .

NOTE: Initialization is NOT required if re-inflating tires to the currently specified tire pressure.

The system will need to be initialized when tires are rotated; tires are inflated to a specification different from currently logged pressures; tire pressure sensor and/or tire pressure monitor ECU are replaced. See Initialization . When a tire pressure sensor and/or tire pressure monitor ECU are replaced, the sensor IDs must be memorized by the tire pressure monitor ECU prior to system initialization. See Registration .

NOTE: Before beginning registration process on vehicles where tire pressure sensors have not been replaced, retrieve sensor transmitter ID(s) using intelligent tester or by reading the ID on the tire pressure sensor. If sensor is being replaced with a new one, make a note of the transmitter ID before installation, as it cannot be seen after sensor is installed. See Figure.